block function is on, change the access code
(
3 digits max.). The default setting is “1”.
Handset
1 MM
ENUN#789
2 MCLEARN
3 Enter the new access code. a MSAVEN
4 MOFFN
Displaying and clearing the
b
locked call count
The total number of blocked calls (up to
65,000) will be displayed.
Handset
1 MM
ENUN#790
R To exit, press MOFFN.
2 MCLEARN
3 MbN: “Yes” a MSELECTN a MOFFN
Base unit
1 MM
ENUN#790
R To exit, press MEXITN.
2 MCLEARN
3 MbN: “Yes” a MSELECTN a MOFFN
Adding to the allow name list
You can allow specific callers to pass through
by adding the caller’s name to the allow name
list even if you do not know the caller’s
number.
You can store up to 100 names (16 characters
max.). If the name stored in the allow name list
matches the incoming Caller ID, the unit rings.
Callers listed in the allow name list are not
required to enter the access code.
Adding allowed names from the
c
aller list
Handset
1 MCN CID
2 MbN: Select the desired entry. a MMENUN
3 MbN:
“Save allow name” a
MSELECTN a MOFFN
Base unit
1 MC
IDN
2 MbN: Select the desired entry. a MSAVEN
3 MbN: “Allow name” a MSELECTN a
MEXITN
Viewing/erasing an entry
Handset
1 MM
ENUN#794
2 MbN: Select the desired entry.
R After viewing, press MOFFN to exit.
3 MERASEN a MbN: “Yes” a MSELECTN
a MOFFN
Base unit
1 MM
ENUN#794
2 MbN: Select the desired entry.
R After viewing, press MEXITN to exit.
3 MERASEN a MbN: “Yes” a MSELECTN
a MEXITN
Erasing all entries
Handset / Base unit
1 MM
ENUN#794
2 MERASEN a MbN: “Yes” a MSELECTN
3 MbN: “Yes” a MSELECTN a MOFFN
Greeting message for automated
c
all block
Handset
W
hen the unit answers a call, a greeting
message is played to the caller.
You can use either:
– your own greeting message and
pre-recorded greeting message
– a pre-recorded greeting message
28
For assistance, please visit http://shop.panasonic.com/support
Automated Call Block
To Next Page
Loading...
