Panasonic KX-TGP500B04 - Page 42

42
KX-TGP500B04/KX-TPA50B04
8.2.9. How to Release the Peer to Peer Mode on Base Unit
8.2.9.1. Set up by Web User Interface
Connections:
Follow the same procedure as “Connections” of “How to Login to Panasonic Administrator Menu (P.35)”.
But except step 1-3 and 1-4 because the IP address is already fixed.
Login to Panasonic Administrator Menu:
Follow the same procedure as “Login to Panasonic Administrator Menu” of “How to Login to Panasonic Administrator
Menu (P.35)”.
• Access to ID ADDRESS for Test : http//192.168.0.241
• Access to ID ADDRESS for Reference : http//192.168.0.240
Configuration:
1. Click [Maintenance] button of tab,and click [Test Mode Setting] on the left menu.
2. Select [Normal mode].
3. Click [Save] button.
4. “Complete” is shown, then restart automatically.
8.2.9.2. Set up by USB Test Mode
Set up Base unit in Test mode through USB. (Refer to USB Test Mode (P.43).)
Note:
: Enter key.
8.2.9.3. Restore IP settings
After releasing Set up by Web User Interface (P.42) or Set up by USB Test Mode (P.42), IP settings have to be restored.
Using phone user interface, restore the IP settings, which is written down by step 1-3 of
“How to Login to Panasonic Administrator Menu (P.35)”.
Step Test Command Content Description
1
ts
Enter test mode Make sure the Echo back “TEST” after this command.
2
mode normal
Set Normal Mode Make sure the Echo back “OK” after this command.
3
z
Exit Test Mode