9
KX-TGP500B04/KX-TPA50B04
4.2.4. Signal Flowchart in the Radio Parts
Reception
A voice signal from TEL line is encoded to digital data "TXDATA" (*1) by DSP (IC504) in a base unit.
Then TXDATA goes to RF PART, and it's modulated to 1.9 GHz. The RF signal is amplified and fed to a selected antenna.
As for a handset RF, RF signal is received in two antennas.
RFIC (IC701) compares RF signal levels and selects the antenna to be used. Then RFIC down-converts to 864 kHz IF signal
from RX signal in the selected antenna, and demodulates it to digital data "RXDATA"(*1).
DSP (IC504) converts RXDATA into a voice signal and outputs it to speaker.
Transmission
A voice signal from microphone is encoded to digital data "TXDATA" by DSP (IC501) in a handset.
Then TXDATA goes to RF PART, and it's modulated to 1.9 GHz. The RF signal is amplified and fed to a selected antenna.
As for a base unit RF, RF signal is received in two antennas.
RFIC (IC701) compares RF signal levels and selects the antenna to be used. Then RFIC down-converts to 864 kHz IF signal
from RX signal in the selected antenna, and demodulates it to digital data "RXDATA".
DSP (IC501) converts RXDATA into a voice signal and outputs it to TEL line.
Note:
(*1) TXDATA and RXDATA are bundled to one signal as "RXTXDATA" of DSP(IC504) in base unit.
To Next Page
Loading...
