PANASONIC PHONE SYSTEM INSTALLATION GUIDE
Model numbers: KX-TGP600, KX-TPA60, KX-TPA65
REVIEW ITEMS INCLUDED WITH YOUR PHONE SYSTEM
Depending on the equipment ordered, you will have the following items included in your shipment:
It is important to note that the initial setup process and registration of your devices can take up to 1 hour. Please ensure that you have
completed the process to charge your handset (if applicable) prior to beginning the installation process.
CONGRATULATIONS ON THE PURCHASE OF YOUR NEW ACN DIGITALTALK® EXPRESS PHONE SYSTEM!
Wireless Base Station
(KX-TGP600)
Ethernet Cable (1)
Desktop Phone
(KX-TPA65)
Screws & Washers for
Desktop Wall Mount (2/2)
Handset Phone
(KX-TPA60)
Handset
Batteries (2)
AC Adaptor for Desktop
Phone (1)
DC Output: 6.5 V
Handset
Belt Clip (1)
AC Adaptor for Base
Station (1)
DC Output: 6.5 V
Desktop
Handset Cord (1)
AC Adaptor for
Handset Charger (1)
DC Output: 5.5 V
Desktop
Handset (1)
Desktop
Stand (1)
Before you begin the installation process, please confirm you have the following:
1. An active Internet connection
2. All devices associated with your new phone system
3. ACN Installation Instructions email (Required for telephone number registration and conguration (see page 2))
Once confirmed you have the items noted above, please review then follow the instructions in sequence below, beginning with Step 1.
STOP
STEP 1 A – SETTING UP THE HANDSET(S) CHARGER / PREPARING THE HANDSET(S) FOR USE
1. Open the battery cover, insert the
batteries and close the cover.
2. Connect the AC adaptor to the charger.
3. Place handset in charger for at least
six (6) hours prior to registration/use.
Bottom of Handset charger
Handset
STEP 1 B – ASSEMBLING THE DESKTOP PHONE(S)
Bottom of Desktop Phone
Desktop Phone
Attach the AC adaptor, corded handset (and headset, where applicable) to the desktop phone.
To Next Page
Need help?
General
Weight and Dimensions
