For assistance, please call: 1-800-211-PANA(7262)
Preparation
7
Display
: In the standby mode, the display shows the current time.
(Ex. 12:00AM)
: During a conversation, the call duration is displayed.
(Ex. 2 hours, 14 minutes, 30 seconds)
: (FLASH) was pressed.
: (PAUSE) was pressed while storing phone numbers.
: ($) was pressed while dialing.
: (#) was pressed while dialing.
: (AUTO/LOWER) was pressed (p. 18, 21).
: (MUTE) was pressed during a conversation (p. 24).
: The unit is in the clock setting mode (p. 12).
: The unit is in the programming mode (p. 10).
: The dial lock mode is set. To cancel the mode, see page 27.
: This display flashes, when the battery power is low. To replace
the batteries, see page 31.
(This display shows all of the possible configurations.)
To Next Page
Loading...
