Panasonic LS-400 Series - Page 7

ORDER GUIDE
Ampliers
Type Appearance Model No. Output Connection method
Connector type
LS-401 (Note 1)
NPN open-collector
transistor two outputs
Use quick-connection cable (4-core) (optional)
LS-401P
PNP open-collector
transistor two outputs
With upper
communication
function (Note 2)
LS-403
NPN open-collector
transistor two outputs
Cable type
(With external input)
LS-401-C2 (Note 1)
NPN open-collector
transistor two outputs
2 m 6.562 ft cabtyre cable (5-core) included
Cable outer diameter: ø3.7 mm ø0.146 in
LS-401P-C2
PNP open-collector
transistor two outputs
Quick-connection cables
Quick-connection cable is not supplied with the connector type amplier. Please order it separately.
Type Appearance Model No. Description
Main cable
(4-core)
CN-74-C1
Length: 1 m 3.281 ft
0.2 mm
2
4-core cabtyre cable,
with connector on one end
Cable outer diameter: ø3.3 mm ø0.130 in
CN-74-C2
Length: 2 m 6.562 ft
CN-74-C5
Length: 5 m 16.404 ft
Sub cable
(2-core)
CN-72-C1
Length: 1 m 3.281 ft
0.2 mm
2
2-core cabtyre cable,
with connector on one end
Cable outer diameter: ø3.3 mm ø0.130 in
CN-72-C2
Length: 2 m 6.562 ft
CN-72-C5
Length: 5 m 16.404 ft
End plates
End plates are not supplied with the amplier. Please order them separately when the ampliers are mounted in cascade.
Type Model No. Description
MS-DIN-E
When cascading multiple ampliers, or when it moves depending on the way it is installed on
a DIN rail, these end plates clamp ampliers into place on both sides. Make sure to use end
plates when cascading multiple ampliers together.
Two pcs. per set
Accessories
• RF-330 (Reector)
• CN-EP1 (Connector for amplier)
5 pcs. per set
(Note)
• LS-MR1 (Lens attachment for line reective type)
Note: One is attached to each
sensor head according to
standard.
• RF-230 (Reector)
Note: LS-H92(F) only
Notes: 1) Obtained Korea’s S-mark certication.
2) For upper communication, a communication unit for open network SC-GU3 series is needed separately.
Digital Laser Sensor LS-400 SERIES
7