Preparation/Basic “Quick Start Guide”
16
DVQX1356 (ENG)
• Check that the access lamp has gone off.
• Push it securely all the way until you hear a click while being careful about the direction in
which you insert it.
To remove the card, push the card until it clicks, then pull the card out upright.
• To insert/remove the card into/from the card slot 1
A, push the top side of the card. To insert/
remove the card into/from the card slot 2
B, push the bottom side of the card.
∫ Card access indicators
• During access (i.e., while the access lamp is lit up or [ ]/[ ] is displayed), do not turn
this unit off, remove the battery, card or disconnect the AC adaptor (optional).
• Change lenses where there is not a lot of dirt or dust.
• Do not press the lens release button A when you attach a lens.
4
Inserting the Card (Optional)
Access lamp
Lights up while the card is
being accessed.
Access indication
Lights up red while an
image is being recorded to
the card.
5
Attaching/Removing the Lens
DC-GH5SPP-DVQX1356_eng.book 16 ページ ２０１７年１２月１２日 火曜日 午後４時５１分
To Next Page
Loading...
