Recording
60
DVQX1356 (ENG)
You can synchronize the initial time code value with an external device that supports time
code input/output.
• You can synchronize the initial time code value with an external device only when
[Count Up] in [Time Code] is set to [FREE RUN] in Creative Video Mode.
A Flash synchro socket
B BNC conversion cable (for TC IN/OUT) (supplied)
C BNC cable
D External device that supports time code input/output.
• Do not use any other BNC conversion cables (for TC IN/OUT) except the supplied one.
• Do not use the BNC cables with the length of 2.8 m (9.2 feet) or more.
• We recommend using a 5C-FB equivalent double-shielded BNC cables.
∫ Connect to an external device/Prepare for synchronization
Preparations:
Turn this unit off.
1 Rotate the flash synchro socket cap in the direction
of the arrow to remove it (1, 2).
• Be careful not to lose the flash synchro socket cap.
2 Insert the BNC conversion cable (3), and rotate the
locking screw in the direction of the arrow to attach
the cable (4).
A Locking screw
3 Connect the BNC conversion cable and the external
device with the BNC cable, and turn on the camera.
4 Set the mode dial to [ ].
5 Select the menu.
∫
Synchronize the time code of the external device with that of the camera (TC OUT)
The initial time code value of the external device is synchronized according to the time
code signal (LTC signal) of the camera.
1 Connect the external device, and follow the steps needed to prepare for time
code synchronization. (P60)
2 Set the time code output type.
Synchronizing the time code with an external device
> [Motion Picture] > [Time Code] > [Count Up] > [FREE RUN]
> [Motion Picture] > [Time Code] > [External TC Setting] >
[TC Output Reference]
DC-GH5SPP-DVQX1356_eng.book 60 ページ ２０１７年１２月１２日 火曜日 午後４時５１分
To Next Page
Loading...
