43
Recording
(ENG) DVQX1356
∫ Setting Pre-Burst Recording ([4K Burst]/[4K Burst(S/S)])
The camera starts recording approximately 1 second before the shutter button is pressed
fully, so you will not miss a photo opportunity.
• Auto Focus operation settings and menus that cannot be set while this function is in use are the
same as those during [4K Pre-Burst] operation.
∫ Setting Loop Recording ([4K Burst(S/S)])
You can perform recording while deleting the oldest recorded data, allowing you to keep
on recording while waiting for a photo opportunity without replacing the card.
• Once you start recording, the 4K burst file will be recorded and divided approximately every
2minutes.
Approximately the last 10 minutes (up to approximately 12 minutes) will be saved. The
preceding part will be deleted.
1 Select an image with the [ ] icon on the playback screen, and
press 3.
• If the image was recorded with [4K Pre-Burst], proceed to step 3.
2 Drag the slide bar to make a rough selection of
scenes.
• If the image was recorded with [4K Burst] or [4K Burst(S/
S)], you can select its scenes on the 4K burst playback
screen by touching [ ] (Fn1).
3 Drag the frames to select the frame you want to save
as a picture.
• To continuously rewind/forward frame-by-frame, touch and
hold [ ]/[ ].
4 Touch [ ] to save the picture.
• A confirmation screen will be displayed.
• The picture will be saved in JPEG format.
> [Rec] > [4K PHOTO] > [Pre-Burst Recording]
> [Rec] > [4K PHOTO] > [Loop Recording(4K PHOTO)]
Selecting pictures from 4K burst file and saving
MENU
MENU
DC-GH5SPP-DVQX1356_eng.book 43 ページ ２０１７年１２月１２日 火曜日 午後４時５１分
To Next Page
Loading...
