159
6. Stabiliser, Zoom and Flash
3
Select the menu.
4
Press 3/4 to select an item and then press [MENU/SET].
• To fire a test flash, press [DISP.].
A Firing Mode
B Flash output
C Luminosity ratio
¢1 Not available when [Wireless FP] is set to [ON].
¢2 This option is not set when the flash (DMW-FL200L: optional) is attached to the camera.
> [Rec] > [Flash]
[Wireless] Select [ON].
[Wireless Channel]
Select the channel you have set for the wireless flashes in
step
2.
[Wireless Setup]
Proceed to step
4.
[External
Flash]
¢1
[Firing Mode]
[TTL]: The camera automatically sets the flash output.
[AUTO]
¢2
: Flash output is set by the external flash.
[MANUAL]: Set the luminosity ratio of the external flash manually.
[OFF]: The flash on the camera side emits only communication light.
[Flash Adjust.]
Set the flash output of the camera manually when [Firing Mode] is set to [TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the external flash when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
[A Group]/
[B Group]/
[C Group]
[Firing Mode]
[TTL]: The camera automatically sets the output.
[AUTO]
¢1
: The wireless flashes automatically set the flash output.
[MANUAL]: Set the luminosity ratio of the wireless flashes manually.
[OFF]: The wireless flashes of the specified group will not fire.
[Flash Adjust.]
Adjust the flash output of the wireless flashes manually when [Firing Mode] is
set to [TTL].
[Manual Flash Adjust.]
Set the luminosity ratio of the wireless flashes when [Firing Mode] is set to
[MANUAL].
• You can set from [1/1] (full brightness) to [1/128] in steps of 1/3.
To Next Page
Loading...
