7. Recording Motion Pictures
196
This displays the waveform monitor or the vectorscope on the recording screen.
1 Select the menu.
2 Press 3/4/2/1 to select the display position, and press [MENU/SET].
• Direct touch operation is also possible from the recording screen.
[WFM/Vector Scope]
> [Creative Video] > [WFM/Vector Scope]
[WAVE]
Displays a waveform.
• The waveform displayed on the camera indicates the luminance as
values based on the conversions below.
– A black level of 0: A luminance value of 16
– A white level of 100: A luminance value of 235
A The range between 0 and 100 shows dotted lines at intervals of 10.
B IRE (Institute of Radio Engineers)
C 109 (dotted line)
D 100
E 50
F 0
G s4 (dotted line)
H Display example
[VECTOR]
Displays the vectorscope.
I R (Red)
J YL (Yellow)
K G (Green)
L MG (Magenta)
M B (Blue)
N CY (Cyan)
O Display example
[OFF] s
To Next Page
Loading...
