307
10. Using the Wi-Fi/Bluetooth function
∫ Send Images Stored in the Camera
Images can be selected and sent after recording.
∫ Changing the settings for sending images
Pressing [DISP.] after completing a connection allows you to change the settings for
sending such as the image size for sending.
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
• The setting is cancelled when the picture is selected
again.
• Pictures are displayed separately by card slot. You can
switch the displayed card by pressing [Fn3].
• You can only select images on one card at a time.
2 Select [OK].
• To terminate the connection, select [Exit].
Not available in these cases:
• Images recorded with a device other than the camera and images modified or edited on a PC
may not be sent.
[Size]
Resize the image to send.
[Original]/[Auto]/[Change] ([M], [S] or [VGA])
• [Auto] is available only for [Web service]. It changes the image size
according to the status of the destination.
[File Format]
(Destination: Only
[Smartphone], [PC])
[JPG]/[RAWiJPG]/[RAW]
[Delete Location
Data]
(Destination: Only [Cloud
Sync. Service], [Web
service])
Select whether to delete the location information from images before
sending them.
[ON]/[OFF]
• This operation only deletes the location information from the images
that are set to be sent.
[Cloud Limit]
(Destination: Only [Cloud
Sync. Service])
You can select whether to send images when the Cloud Folder runs
out of free space.
[ON]: Do not send images.
[OFF]: Delete images from the oldest ones, then send new images.
6HW
ュリヴヱハ
To Next Page
Loading...
