Panasonic Lumix DC-GH5S

341
11. Connecting to other equipment
1 Press 2/1 to select the picture and then press
[MENU/SET].
2 Press 3 to select [Print start] and then press [MENU/
SET].
1 Press 3.
2 Press 3/4 to select an item and then press [MENU/SET].
3 Press 3 to select [Print start] and then press [MENU/SET].
• Disconnect the USB connection cable after printing.
• Use a battery with sufficient battery power or the AC adaptor (optional). If the remaining
battery power becomes low while the camera and the printer are connected, the status
indicator blinks and the alarm beeps. If this happens during printing, stop printing at once. If
not printing, disconnect the USB connection cable.
• Do not disconnect the USB connection cable while [å] (Cable disconnect prohibit icon) is
displayed.
(May not be displayed depending on the type of printer used.)
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
Not available in these cases:
• Motion pictures, 4K burst files, and images recorded with the Post Focus function cannot be
printed.
Selecting a single picture and printing it
Selecting multiple pictures and printing them
[Multi Select]
Multiple pictures are printed at one time.
•Press 3/4/2/1 to select the pictures and then press [MENU/
SET].
(Press [MENU/SET] again to cancel the setting.)
• After the pictures have been selected, press [DISP.].
[Select All] Prints all the stored pictures.
[Rating] Prints all images with [Rating] levels between [¿1] and [¿5].
PictBridge
PictBridge
0XOWL3ULQW
3ULQW