11
• Step 4. Display the Initial Settings:
1. Set [ Shutter speed dial ] to “[ A ](Auto Mode)”.
2. Set [ Aperture ring ] to “[ A ](Auto Mode)”.
3. While pressing [ MENU/SET ] button and “[ RIGHT ] of Cursor buttons” simultaneously, turn the power off.
The “Initial Settings” menu is displayed.
There are two kinds of “Initial Settings” menu form as follows:
[ CASE 1. After replacing Main P.C.B. and/or Flash-ROM ]
[ Except “EB/EF/EG/EP” models: (1PB1DVLB1282Z is used as a Main P.C.B.) ]
When Main P.C.B. has just been replaced, 11 model suffixes are displayed as follows. (two pages in total)
[ Only “EB/EF/EG/EP” models: 1PB1DVLB1282Y is used as a Main P.C.B. ]
When Main P.C.B. has just been replaced, only 4 model suffixes are displayed as follows. (one pages in total)
[ CASE 2. Other than “After replacing Main P.C.B. and/or Flash-ROM” ]
To Next Page
Loading...
