130
DVQP1288
4K Photo and Drive Settings
Selecting a Drive Mode
Burst function
â–
Setting [Burst Rate]
After selecting [Burst] and pressing
in step
2
(→129), select the burst rate with ,
and press [MENU/SET]
[H]
(High speed)
[M]
(Middle speed)
[L]
(Low speed)
Speed (pictures/sec.)
[AFS] 10 5 2
[AFF] / [AFC] 5 5 2
Live View during burst recording None Available Available
Number of
recordable pictures
*
1
With RAW files 10 10 10
Without RAW files 31 100 or more 100 or more
*
1
The number of burst pictures is limited by the picture-taking conditions and the type and/or status
of the card used. Pictures can be taken until the card becomes full. However, the burst speed will
become slower halfway through the recording. The exact time when the slower burst speed will
start depends on the settings of the aspect ratio, picture size, and quality as well as the type of card
used.
Focusing in burst mode
Focusing varies depending on the [AFS/AFF/AFC] in [Rec] menu (→91) and the setting of [Focus/
Release Priority] (→188) in the [Custom] menu.
[AFS/AFF/AFC] [Focus/Release Priority] Focus
[AFS]
[FOCUS]
At the first picture
[RELEASE]
[AFF] / [AFC]
*
2
[FOCUS]
Normal focusing
*
3
[RELEASE]
Predicted focusing
*
4
*
2
Focus is fixed in the first picture when dark subjects are recorded.
*
3
Since the camera records a burst of pictures while it adjusts the focus, the burst speed may be
slower.
*
4
The camera predicts the focus within a possible range by giving higher priority to the burst speed.
To Next Page
Loading...
Need help?
General
