35
DVQP1288
Basics
Buttons/Ring/Dials/Levers Used for Recording
Setting the sensitivity of the eye sensor or setting to switch the display
between the viewfinder and monitor
→ [Custom] → [Eye Sensor]
[Sensitivity] Use this setting to set the sensitivity of the eye sensor.
[LVF/Monitor Switch]
Use this setting to switch the display between the viewfinder and monitor.
[LVF/MON AUTO] (Automatic switching between viewfinder and monitor) /
[LVF] (Viewfinder display) / [MON] (Monitor display)
• After the display is switched using the [LVF] button, the setting of [LVF/
Monitor Switch] will also change.
Zoom Lever (Use Zoom)
You can adjust the area of a picture to be taken using the zoom or control ring.
• You can also use the zoom function from the touch panel. (→145)
• For details about zoom types and use, refer to (→142).
Zoom lever Control ring
1
Move the zoom lever
1
Turn the control ring
*
*
You can perform zoom operation by assigning
the [Zoom] setting to the control ring. (→51)
T side: Telephoto, Enlarge the subject
W side: Wide-angle, Capture a wider area
Turning angle is large: Zoom speed is high
Turning angle is small: Zoom speed is low
Clockwise: Telephoto, Enlarge the subject
Counterclockwise: Wide-angle, Capture a wider
area
●
Do not touch the lens barrel during zooming.
●
Adjust the focus after adjusting the zoom.
●
The camera may make a rattling noise and vibrate when the zoom lever or control ring is
operated. This is not a malfunction.
To Next Page
Loading...
