Preparation
18
SQT0433 (ENG)
Charging
Connect the unit and AC adaptor to charge.
≥ The battery is not charged when this unit is shipped. Charge the battery before use.
≥ For details on charging time, refer to P54.
1
Open the microUSB terminal cover, check the direction of the AC
adaptor cable terminal, and insert it into the microUSB terminal.
2
Insert the AC adaptor power plug into the power outlet.
∫ When charging is complete
1
Remove the AC adaptor power plug from the power outlet.
2 Remove the AC adaptor cable terminal from the unit.
≥ The unit and AC adaptor may become warm while charging, however this is not
a malfunction.
≥ Remove the AC adaptor from the power outlet after completely charging the
battery in order to save power and maintain battery performance.
≥ The shape of the AC adaptor power plug and power outlet may differ depending on
each country/region.
≥ Do not use any other AC adaptors except the supplied one.
≥ Do not leave any metal items (such as clips) near the contact areas of the power
plug.
≥ When you start charging an empty battery, the charging lamp may flash. This is not a
malfunction. The charging lamp stops flashing and lights up after the battery is
charged for a while.
To power outlet
AC adaptor
microUSB terminal
Charging lamp
On: Charging.
Off: Charging has completed.
DMC-CM1P-SQT0433_eng.book 18 ページ ２０１５年４月１３日 月曜日 午後１時１分
To Next Page
Loading...
