36 VQT2X53 (ENG) (ENG) VQT2X53 37
Specifications (Continued)
Hi-speed burst
Burst speed Approx. 4.6 pictures/second
Number of
recordable
pictures
Approx. 15 pictures (When using the built-in
memory, immediately after formatting)
Max. 100 pictures (When using a card, it may differ
depending on the type of card and the recording
conditions)
Shutter speed 8 to 1/1600 th
[STARRY SKY] Mode: 15 seconds, 30 seconds,
60 seconds
Exposure (AE) AUTO (Programme AE)
Exposure Compensation
(1/3 EV Step, -2 EV to +2 EV)
Metering Mode Multiple
LCD monitor 2.7” TFT LCD (4:3) (Approx. 230,400 dots)
(field of view ratio about 100 %)
Flash
Flash range: (ISO ) Approx. 30 cm (0.99 feet)
to 4.9 m (16.08 feet) (Wide)
Microphone Monaural
Speaker Monaural
Recording media Built-in Memory (Approx. 40 MB)/SD Memory Card/
SDHC Memory Card/SDXC Memory Card
Recording file
format
Still picture JPEG (based on Design rule for Camera File
system, based on Exif 2.3 standard)/
DPOF corresponding
Motion
pictures
QuickTime Motion JPEG
(motion pictures with audio)
Interface
Digital USB 2.0 (Full Speed)
Data from the PC can not be written to the camera
using the USB connection cable.
Analogue
video/audio
NTSC / PAL Composite (Switched by menu), Audio
line output (Monaural)
Terminal AV OUT/DIGITAL: Dedicated jack (8 pin)
DC IN: Dedicated jack (2 pin)
Dimensions
Approx. 100.3 mm (W) x 63.5 mm (H) x 21.6 mm (D)
[3.95” (W) x 2.50” (H) x 0.85” (D)]
(excluding the projection part)
Mass With card and battery: Approx. 172
(0.38 lb)
Excluding card and battery: Approx. 152 (0.34 lb)
Operating
temperature
-10 °C
∗
1
to 40 °C
∗
1
The performance of the battery (number of
recordable pictures/operating time) and the LCD
monitor (ghost images appearance, etc.) may
drop temporarily when using the camera between
-10 °C and 0 °C (in cold environments such as a
ski resort).
Operating
humidity
10 %RH to 80 %RH
Waterproof
performance
Equivalent to IEC 60529 ‘IPX8’
(Usable for 60 minutes in water depth of 3 m (10 feet))
Anti-shock
performance
The camera’s test method complies with MIL-STD
810F (Method 516.5-Shock)
∗
2
.
∗
2
‘MIL-STD 810F (Method 516.5-Shock)’ is the test
method standard of the U.S. Defense Department,
which specifies performing drop tests from a
height of 122 cm (4.00 feet), at 26 orientations
(8 corners, 12 ridges, 6 faces) using 5 sets of
devices, and passing the 26 orientation drops
within 5 devices. (If failure occurs during the test,
a new set is used to pass the drop orientation test
within a total of 5 devices)
•
Panasonic’s test method is based on MIL-STD 810F
(Method 516.5-Shock) that is described above, with
the drop height changed from 122 cm (4.00 feet)
to 150 cm (5 feet). The camera cleared a test of
being dropped onto 3 cm (0.10 feet) thick plywood.
(Disregarding exterior changes such as paint peeling
or deformation in the dropping impact areas.)
This is not a guarantee of no breakdowns or
malfunctions under all conditions.
Dustproof
performance
Equivalent to IEC 60529 ‘IP6X’
To Next Page
Loading...
Need help?
General
Weight and Dimensions
