Panasonic LUMIX DMC-FT2 User Manual

3
(ENG) VQT2M41
Caution for AC mains lead
For your safety, please read the following
text carefully.
This appliance is supplied with a moulded
three pin mains plug for your safety and
convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced
please ensure that the replacement fuse
has a rating of 5-ampere and that it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark  or the BSI
mark  on the body of the fuse.
If the plug contains a removable fuse
cover you must ensure that it is refitted
when the fuse is replaced.
If you lose the fuse cover the plug must
not be used until a replacement cover is
obtained.
A replacement fuse cover can be
purchased from your local dealer.
CAUTION!
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET
OUTLET IN YOUR HOME THEN THE
FUSE SHOULD BE REMOVED AND
THE PLUG CUT OFF AND DISPOSED
OF SAFELY.
THERE IS A DANGER OF SEVERE
ELECTRICAL SHOCK IF THE CUT OFF
PLUG IS INSERTED INTO ANY 13-
AMPERE SOCKET.
If a new plug is to be fitted please
observe the wiring code as stated below.
If in any doubt please consult a qualified
electrician.
 IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
Blue: Neutral, Brown: Live.
As these colours may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured Blue must be
connected to the terminal which is marked
with the letter N or coloured Black or Blue.
The wire which is coloured Brown must be
connected to the terminal which is marked
with the letter L or coloured Brown or Red.
WARNING: DO NOT CONNECT EITHER
WIRE TO THE EARTH TERMINAL
WHICH IS MARKED WITH THE LETTER
E, BY THE EARTH SYMBOL  OR
COLOURED GREEN OR
GREEN/YELLOW.
THIS PLUG IS NOT WATERPROOF-
KEEP DRY.
 Before use
Remove the connector cover.
 How to replace the fuse
The location of the fuse differ according to
the type of AC mains plug (figures A and
B). Confirm the AC mains plug fitted and
follow the instructions below.
Illustrations may differ from actual AC
mains plug.
1. Open the fuse cover with a screwdriver.
2. Replace the fuse and close or attach
the fuse cover.
Fuse cover
Figure A Figure B
Figure A Figure B
Fuse
(5 ampere)
Fuse
(5 ampere)
VQT2M41~Safety_eng.fm 3 ページ ２０１０年１月３０日 土曜日 午後５時７分

Panasonic LUMIX DMC-FT2 Specifications

General

Camera type	Compact camera
Sensor type	CCD
Image stabilizer	Yes
Image sensor size	1/2.33 \
Supported aspect ratios	3:2, 4:3, 16:9
Maximum image resolution	4320 x 3240 pixels
Still image resolution(s)	1024 x 768, 2048 x 1536, 2592 x 1944, 3072 x 2304, 3648 x 2056
Digital zoom	4 x
Optical zoom	4.6 x
Combined zoom	39.3 x
Focal length range	4.9 - 22.8 mm
Interface	USB
Digital SLR	No
Power supply type	AC
Aperture range (F-F)	3.3 - 5.9
Camera shutter speed	15 - 60, 1.0 s
Effective sensor resolution	14.1 pixels
Focal length (35mm film equivalent)	28 - 128 mm
Focus adjustment	Auto
Normal focusing range	0.3 - ∞ m
Flash modes	auto, Red-eye reduction, Slow synchronization
Flash range (tele)	0.3 - 2.8 m
Flash range (wide)	0.3 - 5.1 m
Internal memory	40 MB
Compatible memory cards	sd, sdhc, sdxc
Motion JPEG frame rate	30 fps
Maximum video resolution	1280 x 720 pixels
Field of view	100 %
USB version	2.0
Product color	Orange
Waterproof up to	10 m
Scene modes	beach, Candlelight, Children, Close-up (macro), Fireworks, Night portrait, party (indoor), Portrait, self-portrait, Sports, Sunset, Underwater
Image editing	resizing, trimming
Photo effects	black&white, Sepia
White balance	auto, Cloudy, custom modes, daylight, Shade
Camera playback	movie, slide show, thumbnails
Battery capacity	940 mAh
Power requirements	110 - 240V
Battery life (CIPA standard)	360 shots

Weight and Dimensions

Depth	24.3 mm
Width	99.3 mm
Height	63.1 mm
Weight	188 g