VQT2M41 (ENG)
16
1 With the card/battery door and
terminal cover closed, rinse with
water, or if it was used in the sea,
soak the unit in fresh water pooled
in a shallow container for
10 minutes or less.
•
If you have attached the silicon jacket,
be sure to rinse the camera after
removing it.
• Leaving the camera with foreign objects or saline matter on it may cause
damage, discolouration, corrosion, unusual odour, or deterioration.
2 Wipe off the water, and dry the
camera by standing it on a dry
cloth in a well ventilated shaded
area.
3 Confirm there is no water on the
camera, and open the card/battery
door and terminal cover.
4 Wipe off any water or sand inside
the card/battery door and terminal cover with a soft dry cloth.
Caring of the camera after using it underwater
DMC-FT2&TS2EB-VQT2M41_eng.book 16 ページ ２０１０年１月２９日 金曜日 午後７時５９分
To Next Page
Loading...
