Advanced (Recording pictures)
- 114 -
For details on [REC] Mode menu settings, refer to P23.
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to real life.
Applicable modes:
·
[OFF]/[ON]
Note
•
Even when the [SENSITIVITY] is set to [ISO80]/[ISO100], [SENSITIVITY] may be set higher
than [ISO80]/[ISO100] if the picture is taken with [I.EXPOSURE] set to valid.
• Compensation effect may not be achieved depending on the conditions.
• [ ] in the screen turns to yellow when [I.EXPOSURE] is in effect.
For details on [REC] Mode menu settings, refer to P23.
You can take bright pictures in dark places by setting [MIN. SHTR SPEED] slower. Also,
you can set it faster to reduce the blur of the subject.
Applicable modes:
·
[AUTO], [1/250], [1/125], [1/60], [1/30], [1/15], [1/8], [1/4], [1/2], [1]
Note
•
This should usually be set to [AUTO] to take pictures. (When you select a minimum shutter
speed other than [AUTO], [ ] appears on the screen.)
• When [AUTO] is selected, shutter speed may be set up to 1 second when there is not much
jitter to adjust with the [STABILIZER], or when [STABILIZER] is set to [OFF].
• Setting [MIN. SHTR SPEED] to slower speed might increase the chance of jitter, so we
recommend using a tripod and the self-timer for taking pictures.
• Setting [MIN. SHTR SPEED] to faster speed might make the picture darker, so we recommend
recording the picture in a well-lit area. If correct exposure cannot be achieved, [ ] will flash in
red when the shutter button is pressed halfway.
[I.EXPOSURE]
[MIN. SHTR SPEED]
Minimum shutter speed setting 1/250 1
Brightness Darker Brighter
Jitter Less More
To Next Page
Loading...
