Preparation
- 12 -
The AC Adaptor (optional) can only be used with
the designated Panasonic DC coupler (optional).
The AC adaptor (optional) cannot be used by
itself.
1 Open the card/battery door.
2 Insert the DC coupler, being careful of the
direction.
3 Open the DC coupler cover A.
•
Push open the coupler cover from the interior.
4 Close the card/battery door.
5 Plug the AC adaptor into an electrical outlet.
6 Connect the AC adaptor B to the [DC IN] socket
C of the DC coupler.
D Align the marks and insert.
• Ensure that only the AC adaptor and DC coupler for
this camera are used. Using any other equipment may
cause damage.
Note
•
Always use a genuine Panasonic AC adaptor (optional).
• When using an AC adaptor, use the AC cable supplied with the AC adaptor.
• Some tripods cannot be attached when the DC coupler is connected.
• Make sure to unplug the AC adaptor when you open the card/battery door.
• If the AC adaptor and DC coupler are not necessary, then remove them from the digital
camera. Also, please keep the DC coupler cover closed.
• Also read the operating instructions for the AC adaptor and DC coupler.
Using an AC adaptor (optional) and a DC coupler (optional) instead of the battery
To Next Page
Loading...
Need help?
General
