11
3.4.2. INITIAL SETTINGS:
After replacing the MAIN P.C.B., make sure to perform the initial settings after achieving the adjustment by ordering the following
procedure in accordance with model suffix of the unit.
1. IMPORTANT NOTICE:
Before proceeding Initial settings, make sure to read the following CAUTIONS.
2. PROCEDURES:
• Precautions: Read the above “CAUTION 1” and “CAUTION 2”, carefully.
• Preparation:
- Attach the Battery or AC Adaptor with a DC coupler to the unit.
(Since this unit has built-in memory, it can be performed without inserting SD memory card.)
- Remove the lens cap.
• Step 1. The temporary cancellation of “INITIAL SETTINGS”:
Set the mode dial to “[ P ] (Program AE mode)”.
While pressing “[ UP ] of Cursor button” and [ MOTION PICTURE ] button simultaneously, turn the Power on.
• Step 2. The cancellation of “INITIAL SETTINGS”:
Press the [ PLAYBACK ] button, then playback the picture.
Press “[ UP ] of Cursor button” and [ MOTION PICTURE ] button simultaneously, then turn the Power off.
The LCD displays the “ ! ” mark before the unit powers down.
• Step 3. Turn the Power on:
Set the mode dial to “[ P ] (Program AE mode)”, and then turn the Power on.
• Step 4. Display the INITIAL SETTING:
While pressing [ MENU/SET ] and “[ RIGHT ] of Cursor buttons” simultaneously, turn the Power off.
The “INITIAL SETTINGS” menu is displayed.
There are two kinds of “INITIAL SETTINGS” menu form as follows:
To Next Page
Loading...
Need help?
General
