Others
110
Conditions Causes
When connecting to a
PC, pictures cannot be
transferred.
Is the camera connected to the PC correctly?
Check it.
Is the camera recognized by the PC correctly?
Is the USB mode set correctly?
The clock setting is
reset.
If you do not use the camera for a long time, the clock setting
may be reset. When the message [PLEASE SET THE
CLOCK] appears, set the clock again.
When you take a picture before setting the clock,
[0:00 0. 0. 0] is recorded.
A certain part of the
picture blinks.
This appears due to the highlight display function which
shows white saturated areas. (P29)
When the shutter button
is pressed halfway, a red
lamp turns on
sometimes.
In dark places, the AF assist lamp (P75) lights red to make it
easier to focus on a subject.
The camera will make
sounds caused by
internal mechanical
movement when it is
shaken.
The sound arises when the lens moves.
This is not a malfunction.
The lens clicks. When brightness has changed due to the zoom or the
movement of the camera or other, the lens may click and the
picture on the screen may be drastically changed, however,
the pictures are not affected.
The sound is caused by automatic adjustment of the
aperture. It is not a malfunction.
Some pixels are inactive
or always lit on the LCD
monitor.
This is not a malfunction.
These pixels do not affect the recorded pictures.
Noise appears on the
LCD monitor.
In dark places, noise may appear to maintain the brightness
of the LCD monitor. This does not affect the pictures you are
recording.
A vertical red spectrum
appears on the LCD
monitor.
This is called smear. It is specific to CCD, not a malfunction.
It appears when the subject has a bright part. It is recorded
on motion images, but not recorded on still pictures.
The pictures cannot be
printed with printers
supporting PictBridge.
Set the USB mode to [PictBridge (PTP)].
FZ3-PP.book 110 ページ ２００４年６月２１日 月曜日 午後７時６分
To Next Page
Loading...
Need help?
General
