VQT2G40 (ENG)
16
Preparation
Inserting and Removing the Card (optional)/the
Battery
• Check that this unit is turned off.
• Close the flash.
• We recommend using a Panasonic card.
Slide the card/battery door to open it.
• Always use genuine Panasonic batteries
(CGR-S006A).
• If you use other batteries, we cannot guarantee the
quality of this product.
Battery: Insert until it is locked by
the lever A being careful about the
direction you insert it. Pull the lever
A in the direction of the arrow to
remove the battery.
Card: Push it fully until it clicks
being careful about the direction
you insert it. To remove the card,
push the card until it clicks, then
pull the card out upright.
B: Do not touch the connection terminals of
the card.
•
The card may be damaged if it is not fully
inserted.
1:Close the card/battery door.
2:Slide the card/battery door to the end
and then close it firmly.
• If the card/battery door cannot be completely
closed, remove the card, check its direction and
then insert it again.
VQT2G40~Body1_eng.fm 16 ページ ２００９年７月１日 水曜日 午後６時３９分
To Next Page
Loading...
