Recording
- 138 -
• When you align the subject on the horizontal and vertical guidelines or the cross point of these
lines, you can take pictures with well-designed composition by viewing the size, the slope and
the balance of the subject.
• If there are any white saturated areas, we
recommend compensating the exposure towards
negative (P76) referring to the histogram (P137) and
then taking the picture again. It may result in a better
quality picture.
• There may be white saturated areas if the distance
between the camera and the subject is too close
when taking pictures with the flash.
If [HIGHLIGHT] is set to [ON] in this case, the area directly illuminated by the photo flash will
become white saturated and appear blinking in black and white.
• This does not work while in Multi Playback (P49), Calendar Playback (P50), or Playback Zoom
(P51).
• Set to [ON] to display the [EXPO.METER] when correcting
exposure, performing Programme Shift, setting aperture, and setting
shutter speed.
• Unsuitable areas of the range are displayed in red.
• When [EXPO.METER] is not displayed, switch the display
information for LCD monitor/viewfinder by pressing [DISP.]. (P37)
• The [EXPO.METER] disappears after approximately
4 seconds if no operation is performed.
[GUIDE LINE]
This will set the pattern of guide lines displayed when taking a picture.
[OFF]/[ ]/[ ]
[]:
Position can be set by dragging the
[ ] on the guide line (P12).
•
When it is difficult to move the guide line on
the screen edge by touch operation, use the
cursor button to set the position.
• Direct touch operation is also possible from
the recording screen.
[HIGHLIGHT]
When the Auto Review function is activated or when playing back,
white saturated areas appear blinking in black and white.
[OFF]/[ON]
[EXPO.METER]
Set whether or not to display the exposure meter.
[OFF]/[ON]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
