- 151 -
Playback/Editing
You can add text (comments) to pictures. After text has been registered, it can be stamped
in prints using [TEXT STAMP] (P152).
1 Select [TITLE EDIT] on the [PLAYBACK] Mode menu. (P56)
2 Press 3/4 to select [SINGLE] or [MULTI] and then press [MENU/SET].
•
Collective editing in a group unit is possible by selecting a picture with burst icon [˜].
For [SINGLE IN BURST GROUP] and [MULTI IN BURST GROUP], refer to
P146.
4 Enter the text. (P122)
•
Exit the menu after it is set.
Note
•
To delete the title, erase all the text in the text input screen.
• You can print out texts (comments) using the “PHOTOfunSTUDIO” bundled software on the
CD-ROM (supplied).
• You can set up to 100 pictures at one time with [MULTI].
• Title editing is disabled during the following conditions:
– Motion pictures
– Pictures taken with [ ], [ ] or [ ]
– Pictures recorded with other equipment
[TITLE EDIT]
3
Select the picture, and then press
[MENU/SET] to set.
•
[’] is displayed for pictures with titles
already registered.
[MULTI] setting
Select the picture with 3/4/2/1 and
set (repeat) by pressing [MENU/SET],
then press
2 a few times to select [OK],
and execute by pressing [MENU/SET].
• The setting is cancelled when
[MENU/SET] is pressed again.
[SINGLE] [MULTI]
Press 2/1 to select
the picture.
Press 3/4/2/1 to
select the pictures.