Others
- 196 -
[READ ERROR/WRITE ERROR
PLEASE CHECK THE CARD]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.
> Insert a different card.
[CANNOT RECORD DUE TO INCOMPATIBLE FORMAT (NTSC/PAL) DATA ON THIS
CARD.]
> If you want to delete some pictures, format the card after saving necessary data on a PC
etc. (P68)
> Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
Use a card with SD Speed Class with “Class 4” or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with “Class 6” or higher when recording motion pictures
in [MOTION JPEG].
• In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P68).
• Depending on the type of the card, motion picture recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc. (P68) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P68)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
•
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P66)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P176,
178)
[EDITING OPERATION CANNOT PROCEED AS INFORMATION PROCESSING IS
ONGOING.]
When a card with pictures deleted or file names changed using a PC or other device is
inserted into this unit, it will automatically retrieve new information and reconstruct the
burst groups. The currently retrieving information icon [ ] may be displayed in the
playback screen for long period of time when there are many image files, and deletion or
[PLAYBACK] Mode menu cannot be used during this time.
•
If you switch the power switch to [OFF] while information is being retrieved, the pictures for
which information was retrieved up to that point will be saved as a burst group. When you
switch on again, the information retrieval will restart from the same point.
[Lens not detected. Please turn camera on again.]
•
This is displayed when the lens has stopped operating normally due to being pressed on by a
hand etc.
> Turn the camera off and on. If the message persists, contact the dealer or your nearest
Service Centre.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
