- 75 -
Recording
• If the distance to the subject is close when taking a picture using a flash, part of the recorded
image becomes dark because the light of flash is blocked by the lens or it becomes out of flash
range. Check the distance to the subject when taking a picture. Distance to the subject where
the light of flash is blocked depends on the lens used.
– When the interchangeable lens (H-FS014042) is attached:
50 cm (1.64 feet) or less (Wide)/30 cm (0.99 feet) or less (Tele)
– When the interchangeable lens (H-FS045200) is attached:
1.0 m (3.28 feet) or less
– When the interchangeable lens (H-PS14042) is attached:
30 cm (0.99 feet) or less (Wide)/30 cm (0.99 feet) or less (Tele)
∫ Shutter speed for each flash setting
¢1 This becomes 60 seconds in Shutter-Priority AE Mode.
¢2
This becomes 60 seconds in Shutter-Priority AE Mode and B (Bulb) in the Manual Exposure Mode.
¢3 This becomes B (Bulb) in the Manual Exposure Mode.
• When the flash is activated the fastest shutter speed that can be selected is 1/160 of a second.
• In Intelligent Auto Mode, shutter speed changes depending on the identified scene.
Note
•
Do not bring the flash too close to objects or close the flash while it is activated. The objects
may be discoloured by its heat or lighting.
• Do not close the flash soon after the flash is activated prior to taking pictures due to AUTO/
Red-Eye Reduction etc. It causes a malfunction.
• Flash pictures taken closer or beyond the flash’s rated distance may appear too bright or too
dark.
• You must wait a moment to take the next picture while the flash icon is blinking RED indicating
the flash is charging.
• When you take a picture beyond the available flash range, white balance may be set
incorrectly.
• When you use certain lenses, light from the flash may be blocked or fail to cover the lens
field of view, causing dark areas to appear in the resulting pictures.
• When taking pictures with flash with the lens hood attached, the lower portion of the photo may
turn dark (vignetting effect) and the control of the flash may be disabled because the photo
flash may be obscured by the lens hood. We recommend detaching the lens hood.
• It may take time to charge the flash if you repeat taking a picture. Take a picture after the
access indication disappears.
• The Red-Eye Reduction effect differs between people. Also, if the subject was far away from
the camera or was not looking at the first flash, the effect may not be evident.
• When you attach an external flash, it takes priority over the built-in flash. Refer to P182 for the
external flash.
Flash setting Shutter speed (Sec.) Flash setting Shutter speed (Sec.)
‡
1/60
¢1
to 1/4000th 1 to 1/4000th
‰
1/60
¢2
to 1/160th Π60
¢3
to 1/4000th
To Next Page
Loading...
Need help?
General
Weight and Dimensions
