29
Error Code List
The error code consists of 8 bit data and it shows the following information.
Important notice about “Error Code List”
About “*” indication:
The third digit from the left is different as follows.
- In case of 0 (example: 2B0
01000)
When the third digit from the left shows “0”, this error occurred under the condition of INITIAL SETTINGS has been com-
pleted.
It means that this error is occurred basically at user side.
- In case of 8 (example: 2B8
01000)
When the third digit from the left shows “8”, this error occurred under the condition of INITIAL SETTINGS has been
released.
(Example; Factory assembling-line before unit shipment, Service mode etc.)
It means that this error is occurred at service side.
• Step 3. How to exit from Error Code display mode:
Simply, turn the power off. (Since Error Code display mode is executed under the condition of temporary cancellation of
“INITIAL SETTINGS”, it wake up with normal condition when turn off the power.)
NOTE:
The error code can not be initialized.
Attribute Main item
Sub
item Error
code
Contents Error Indication
High
4 bits
Low
4 bits Detecting Problematic
device Part/Circuit
HARD FLASH Flash
2a·o
0000
Flash charging capacitor did not been fully charged within 20 seconds
STRBCHG
STRB PCB/
FPC
FLA
SH
ROM Data Area
2B·o
0001
Fla
sh
ROM data reading error is detected when the unit turns
ON
FROM
RE
FROM
0002 Flash ROM data writing error is detected when the unit turns OFF FROM WR FROM
Program Area 0005 Firmware update error (No indication) (No indication)
SYSTEMIC
Initialization
2c·o
0001
Clock
IC
initialization failure error SYS INIT MAIN PCB
SOFT CPU Reset
30•0
0001
System error(
NMI
reset)
I
NMI RST MAIN PCB
0007
Recording Memory card
31•0
0001
Memory card logic error
Media Memory card format error
When it is detected, [ MEMORY CARD ERROR FORMAT THIS CARD? )
is displayed on the screen
SO
CARD
0002
Memory card physical error SD CARD/DSP
During formatting the memory card, there is no response from the memory card
If the mini-SO memory card is used, check the SD memory card adaptor
0004 Memory card writing error
SO
WRITE
Check the memory card. It might be damage one.
Lens
Communication
3C11
****
Lens
communication
error
I
ZOOM
ZOOMm/
3CF0
LENSu
Camera System
3B·o
0000 Initialization failure error INIT
(No indication)
3E•o
0001
Exposure charging operat
ion
failure(Mount Box Unit)
0002 Failure of the returning operation to the home position(Mount Box Unit)
0003
Failure of the mecha shutter sensor(Mount Box Unit) (No indication)
(
No
indication)
Recording Motion Image
3F•o
0001
File
time
out
error
in
recording
motion
image
Recording
0002
File
data
cue
send
error
in
recording
motion
image
Wi-Fi
3211
0001
Wi-Fi related errors:
I I
•Generall
y,
above are unable to specified the, which cannot be used for malfunction diagnosis.
3214 FFFF
To Next Page
Loading...
