Panasonic LUMIX DMC-GF6K Series

8
2.4. How to Replace the Lithium Battery
2.4.1. Replacement Procedure
1. Remove the MAIN P.C.B.. (Refer to Disassembly Procedures.)
2. Remove the Lithium battery (Ref. No. “B9001” at foil side of MAIN P.C.B.) and then replace it into new one.
NOTE:
This Lithium battery is a critical component.
(Type No.: ML614 Manufactured by Energy Company, Panasonic Corporation.)
It must never be subjected to excessive heat or discharge.
It must therefore only be fitted in requirement designed specifically for its use.
Replacement batteries must be of same type and manufacture.
They must be fitted in the same manner and location as the original battery, with the correct polarity contacts observed.
Do not attempt to re-charge the old battery or re-use it for any other purpose.
It should be disposed of in waste products destined for burial rather than incineration.
NOTE:
Above caution is applicable for a battery pack which is for DMC-GF6K/GF6X/GF6W series, as well.
Insert the screwdriver for
removing the Lithium Battery.
(For English)
CAUTION
MAIN P.C.B.
(FOIL SIDE)
Danger
of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
(For German)
ACHTUNG
Explosionsgefahr bei falschem Anbringen der Batterie. Ersetzen Sie nur mit einem
aquivalentem vom Hersteller empfohlenem Typ.
Behandeln Sie gebrauchte Batterien nach den Anweisungen des Herstellers.
(For French)
MISE EN GARDE
Une batterie de remplacement inappropriee peut exploser. Ne remplacez qu'avec une
batterie identique
ou d'un type recommande par le fabricant. L'elimination des batteries
usees doit etre faite conformement aux instructions du manufacturier.