50
(Fig. D20)
9.1.3.14. Removal of the Flash Unit
(Fig. D21)
How to Install
1.
Insert the speaker to the speaker holder.
2.
Insert the LED to the speaker holder.
3.
Insert the hole
of
audio Wi-Fi FPC unit to the
positioning pin
of
the speaker holder.
Positioning Pin
Speaker Holder
4.
Bend the FPC, and then set the mic damper to the
speaker side
of
speaker holder.
5.
Insert the convex part
of
speaker to the slot of a
speaker holder.
C
f
S
k
Groove
of
Speaker Holder
onvex o pea er
-----;;(
~~-
"
0
~'
Mic
Damper----»
'-;'
',
NOTE: (When Installing)
• Take care not to damage the flex.
• Flash Shaft • Locking tab
x 4
• Flash Spring A • Flash Arm Cover
• Flash
1 Unit • Screw (V) x 1
Flash Shaft
• Pull the flash shaft.
Flash
1 Unit
Flash Spring A
Locking tab
- Flash Arm Cover
·.-'.
, Locking tab
\ \ \ \
NOTE: (When Replacing)
• When replacing the Flash arm cover, Flash arm is
also replaced simultaneously.
Screw (V)
_j_
1f-----, 2.5mm
BLACK
To Next Page
Loading...
