265
11. Using the Wi-Fi function
1 Select the menu. (P53)
2 Select [Via Network] or [Direct], and connect. (P287)
3 Select a device you want to connect.
4 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P295)
5 Take pictures.
•
The pictures are sent automatically after taking them.
• To change the setting or disconnect, press [Wi-Fi]. (P250)
You cannot change the settings while sending pictures. Wait until sending is complete.
(You can also terminate the connection by performing the following operations:
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [Yes])
Sending an image each time a recording is made ([Send Images While
Recording])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images While Recording] > [Smartphone]
On your smartphone
When connecting with [Via Network]:
1 Turn on the Wi-Fi function.
2 Select the wireless access point you want to connect to, and set.
3 Start “Image App”. (P253)
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]:
1 Start “Image App”. (P253)
When connecting with [Manual Connection] in [Direct]:
1 Turn on the Wi-Fi function.
2 Select the SSID that matches the one displayed on the screen of this unit.
•
The connection confirmation screen is displayed on the camera. Select [Yes].
(Only when connecting for the first time)
3 Start “Image App”. (P253)
MENU
To Next Page
Loading...
