11. Using the Wi-Fi function
266
1 Select the menu. (P53)
2 Select [Via Network] or [Direct], and connect. (P287)
3 Select a device you want to connect.
4 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P295)
5 Select [Single Select] or [Multi Select].
Select and send the images ([Send Images Stored in the Camera])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images Stored in the Camera] > [Smartphone]
On your smartphone
When connecting with [Via Network]:
1 Turn on the Wi-Fi function.
2 Select the wireless access point you want to connect to, and set.
3 Start “Image App”. (P253)
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]:
1 Start “Image App”. (P253)
When connecting with [Manual Connection] in [Direct]:
1 Turn on the Wi-Fi function.
2 Select the SSID that matches the one displayed on the screen of this unit.
•
The connection confirmation screen is displayed on the camera. Select [Yes].
(Only when connecting for the first time)
3 Start “Image App”. (P253)
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is cancelled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi Select]
is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
To Next Page
Loading...
