36
VQT1C63
Basic
3 Press w/q to select the picture
and then press r to set.
(Only when selecting [MULTI DELETE])
• Repeat the above procedure.
• The selected pictures appear with [A].
When r is pressed again, the setting is
canceled.
• The icon [c] blinks red if the selected
picture cannot be deleted. Cancel the
protect setting. (P79)
4 Press [A].
5 Press e to select [YES] and then
press [MENU/SET] to set.
(Screen when selecting [MULTI DELETE])
• When you delete all pictures, only
pictures in either of the built-in memory
or the card can be deleted. (You cannot
delete pictures in both the built-in
memory and the card at the same time.)
• [DELETE ALL PICTURES ON THE
BUILT-IN MEMORY ?] or [DELETE ALL
PICTURES ON THE MEMORY CARD ?]
is displayed when using [ALL DELETE],
and [DELETE ALL EXCEPT ★?] is
displayed when using [ALL DELETE
EXCEPT ★].
• If you press [MENU/SET] while deleting
pictures using [ALL DELETE] or [ALL
DELETE EXCEPT ★], the deleting will
stop halfway.
• Do not turn off the camera while deleting.
• When deleting pictures, use batteries
with suffi cient battery power (P24) or use
the AC adaptor (DMW-AC6; optional).
• It is possible to delete up to 50 pictures at
one time using [MULTI DELETE].
• The more pictures there are to delete, the
more time it takes.
• In the following cases, pictures are not
deleted even if [ALL DELETE] or [ALL
DELETE EXCEPT
★] is selected.
– When the Write-protect switch of the
SD Memory Card or SDHC Memory
Card is set to the [LOCK] side (P16)
– When fi les do not conform to the DCF
(P34)
– When pictures are protected [c]
(P79)
MENU
7
10
98
11
SELECT
EXIT
MULTI DELETE
MARK/UNMARK
DELETE
MENU
SET
MENU
SELECT SET
MULTI DELETE
YES
NO
DELETE THE PICTURES
YOU MARKED ?
To Next Page
Loading...
