144
SQW0038
Shutter and Drive Settings
Burst function
●
When the burst speed is set to [H] and if many burst pictures are taken, the burst speed may be
reduced while burst pictures are being taken.
●
When the burst speed is set to [SH] or [H] (the focus mode is set to [AFS] or [MF]), and the
exposure and White Balance are fixed to those of the first picture.
When the burst speed is set to [H] (the focus mode is set to [AFF] or [AFC]), [M], or [L], and the
exposure and White Balance are adjusted individually for each still picture.
●
Burst speed may be reduced if shutter speed (pictures/sec.) is reduced in darker locations.
●
With repeated recordings, it may take a while between recordings, depending on the usage
conditions.
●
It may take a while to store still pictures that were taken using the burst function. If you
continue to record while storing, the number of burst pictures that can be taken will be
reduced. A high-speed card is recommended when recording using the burst function.
Not available in the following cases:
●
The Burst Mode is disabled in the following cases:
• When the picture effect (Filter) is set ([Rough Monochrome], [Silky Monochrome],
[Miniature Effect], [Soft Focus], [Star Filter], [Sunshine])
• When White Balance Bracket is set
• When using [Time Lapse Shot]
• When using [Stop Motion Animation] (only available with [Auto Shooting] setting)
• During motion picture recording
• When [4K PHOTO] is set to [ON]
• When recording using the flash
• During T (time) recording
• When recording with [iHandheld Night Shot]
• When [HDR] is set to [ON]
• When [Multi Exp.] is set
• When [Simultaneous record w/o filter] is set to [ON]
●
[SH] in Burst Mode cannot be used In the following cases:
• When [Quality] is set to [
], [ ] or [ ]
• When using [Stop Motion Animation]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
