●
The setting is fixed to [OFF] in [High Sens.] Scene Mode.
 ●
Cannot change the setting in [Motion Picture] Mode. The setting in other Recording 
Mode is applied. 
 [Burst]
Enables a rapid succession of still pictures to be taken. Succession of still pictures taken 
while shutter button is held down.
 ■
Mode:      
 ■
Settings:   /[OFF]
Speed No. of pictures
DMC-S3 Approx. 2 pictures/sec
 
Until card/built-in memory is full
DMC-S1
The burst speed differs according 
to the writing speed of the card and 
picture size.
 ●
Focus is fixed from first picture. Exposure and White Balance is adjusted for each 
picture.
 ●
Burst speed may be reduced if ISO Sensitivity is set to high, or if shutter speed is 
reduced in darker locations.
 ●
When burst is selected, the flash is disabled. 
 ●
When you record subjects in motion where there is a significant difference between 
light and dark areas, it may not be possible to achieve the optimal exposure.
 ●
The setting is fixed to [OFF] in [Panorama Assist] and [Fireworks] Scene Modes.
 [Color Mode]
Set colour effects.
 ■
Mode:       
 ■
Settings:  [STANDARD] / [NATURAL] (soft) / [VIVID] (sharp) / [B/W] / [SEPIA] / 
[COOL] (more blue) / [WARM] (more red)
 ●
If interference is noticeable in dark locations: Set to [NATURAL].
 ●
In   ([Intelligent Auto] Mode), [STANDARD], [B/W], and [SEPIA] can only be set.
 [AF Assist Lamp]
Illuminates lamp when dark to facilitate focus alignment.
 ■
Mode:   
AF Assist Lamp
 ■
Settings: [ON]:     Lamp illuminated with halfway press of shutter 
button (  and larger AF area displayed)
[OFF]: Lamp off (taking pictures of animals in dark, etc.)
 ●
The AF Assist Lamp has an effective distance of 1 m (3.28 feet).
 • Do not block the lamp with your fingers or look at it from close 
range.
 • The AF Assist Lamp’s effective distance becomes shorter when 
using the zoom and depending on subject conditions.
 ●
The setting is fixed to [OFF] in the following Scene Modes.
[Self Portrait], [Night Scenery], [Scenery], [Sunset], [Fireworks]
 ●
Cannot change the setting in [Motion Picture] Mode. The setting in 
other Recording Mode is applied. 
 [Red-Eye Removal] (DMC-S3 only)
Automatically detects red-eye and corrects still picture data when recording with flash 
Red-Eye Reduction (     ).
 ■
Mode:   
 ■
Settings: [ON]/[OFF]
 ●
Available only when [AF Mode] is set to   (Face Detection).
 ●
The red-eye effect may not be corrected under certain conditions.
 ●
When [ON] is selected,   is displayed in the flash icon.