72 VQT3E65 VQT3E65 73
Meanings and required responses to major messages displayed on LCD monitor.
Message displays
[Some pictures cannot be deleted] [This picture cannot be deleted]
●
Non-DCF pictures (→22) cannot be deleted.
→ Save needed data on a computer or other device, and then use [Format] on the
camera. (→30)
[No additional selections can be made]
●
The number of pictures that can be deleted at once has exceeded.
●
More than 999 pictures have been set as [Favorite].
●
The number of pictures allowing [Resize] (multiple settings) at once has exceeded.
[Please turn camera off and then on again] [System Error]
●
The lens is not working correctly.
→ Turn on power again.
(Consult the dealer or your nearest Service Centre if display still remains)
[Some pictures cannot be copied] [Copy could not be completed]
●
Pictures cannot be copied in the following cases:
→ Picture of same name already exists in built-in memory when copying from card.
→ File is not of DCF standard.
→ Picture taken or edited on a different device.
[Not enough space on built-in memory] [Not enough memory on the card]
●
There is no space left on the built-in memory or the card. When you copy pictures from
the built-in memory to the card (batch copy), the pictures are copied until the capacity
of the card becomes full.
[Built-In Memory Error] [Format built-in memory?]
●
Displayed when formatting built-in memory via computer, etc.
→ Reformat directly using camera. Data will be deleted.
[Memory card error. This card cannot be used in this camera. Format this card?]
●
The card format cannot be used with this camera.
→ Save needed data on a computer or other device, and then use [Format] on the
camera. (→30)
[Insert SD card again] [Try another card]
●
Access to card has failed.
→ Insert card again.
●
Try with a different card.
[Memory Card Error] [Memory card parameter error]
●
Card is not of SD standard.
●
When cards in capacities of 4 GB or more are used, only SDHC or SDXC Memory
Cards are supported.
[Read Error]/[Write Error] [Please check the card]
●
Data read has failed.
→ Check whether card has been inserted correctly (→11).
●
Data write has failed.
→ Turn off power and remove card, before re-inserting and turning on power again.
●
Card may possibly be damaged.
●
Try with a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the
card]
●
When recording motion picture, use a card rated with an SD speed class
∗
of “Class 6”
or higher.
∗
SD speed class refers to a specification for sustained write speeds.
●
If recording stops even when using a card with speed of “Class 6” or faster, the data
writing speed is low. We recommend backing up the data on the memory card and
reformatting it. (→30)
●
Motion picture recording may be automatically terminated with certain cards.
[A folder cannot be created]
●
Folder numbers in use have reached 999.
→ Save needed data on a computer or other device, and then use [Format] on the
camera. (→30)
[Picture is displayed for 16:9 TV] [Picture is displayed for 4:3 TV]
●
AV cable is connected to camera.
→ To remove message immediately → Press [MENU/SET].
→ To change aspect ratio → Change [TV Aspect] (→29).
●
USB connection cable is only connected to camera.
→ Message disappears when cable is also connected to another device.
To Next Page
Loading...
