- 159 -
Connecting to other equipment
∫ Disconnecting the USB connection cable safely
•
Proceed with the hardware removal using “Safely Remove Hardware” on the task tray of the
PC. If the icon is not displayed, check that [ACCESS] is not displayed on the LCD monitor of
the digital camera before removing the hardware.
Note
•
Turn the camera off before connecting or disconnecting the AC adaptor (optional).
• Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
• If the camera is connected in clipboard mode, the built-in memory data is displayed even if a
card is inserted.
• HDMI connection is disabled and connection with the USB connection cable will take priority
when you connect the USB connection cable while the HDMI mini cable is connected (P148).
∫ Viewing the contents of the built-in memory or card using the PC (folder
composition)
Folders and images processed in the PC cannot be played back on the camera. It is
recommended to use the “
PHOTOfunSTUDIO 3.0 HD Edition” bundled software on the
CD-ROM (supplied) when you write the image from PC to a card.
A new folder is created when pictures are taken in the following situations.
•
After [NO.RESET] (P33) in the [SETUP] menu has been executed
• When a card containing a folder with the same folder number has been inserted (Such as when
pictures were taken using another make of camera)
• When there is a picture with file number 999 inside the folder
1 Folder number
2 File number
3 JPG: Pictures
MOV: Motion pictures
MISC: DPOF print
Favourite
PRIVATE1:
(Built in memory only)
Clipboard pictures
AVCHD: [AVCHD Lite] Motion
pictures
To Next Page
Loading...
Need help?
General
