EasyManuals Logo

Panasonic Lumix DMC-TS1 User Manual

Panasonic Lumix DMC-TS1
193 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #180 background imageLoading...
Page #180 background image
Others
- 180 -
Is the mode dial correctly set?
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory. (P52)
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> When it is dirty, lightly wipe the surface of the lens with soft and dry cloth.
Was this picture taken with the flash at the close range when the zoom is near [W] (1k)?
> Zoom in a little, and then take the pictures. (P47)
Is this a picture taken in [PIN HOLE] in scene mode?
> Check that the exposure is correctly compensated. (P64)
Setting the [MIN. SHTR SPEED] to faster speed might make the picture darker.
> Set the [MIN. SHTR SPEED] (P114) to slower speed.
> Set auto bracket (P65), [HI-SPEED BURST] (P75), [FLASH BURST] (P76) in Scene mode
or [BURST] (P112) of the [REC] mode menu to [OFF].
The focus range varies depending on the recording mode.
> Set to the proper mode for the distance to the subject.
The subject is beyond the focus range of the camera. (P44)
There is camera shake (jitter) or the subject is moving slightly. (P46)
Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest service centre.
> The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P38)
> When taking pictures at a slow shutter speed, use the self-timer. (P63)
Is the number of recordable pictures 2 or less?
Recording
The picture cannot be recorded.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The auto-focus and other operations are not working normally.
The recorded picture is blurred.
The optical image stabilizer is not effective.
Taking pictures using auto bracket is not possible.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Panasonic Lumix DMC-TS1 and is the answer not in the manual?

Panasonic Lumix DMC-TS1 Specifications

General IconGeneral
BrandPanasonic
ModelLumix DMC-TS1
CategoryDigital Camera
LanguageEnglish

Related product manuals