VQT2M30 (ENG)
10
Maintenance and Waterproof Performance
∫ To prevent water leaking into the camera, observe the following
items before using it.
∫ Check that there is enough remaining battery power or memory in
the card.
∫ Do not open or close the card/battery door or terminal cover in
places with sand and dust, or with wet hands.
∫ At purchase, the [LOCK] switch is in the locked state. When opening
the card/battery door and terminal cover, first release the lock.
•
Release the lock by sliding the [LOCK] switch in the direction of the arrow until
the red area becomes visible, and open the card/battery door and terminal
cover.
A: [LOCK] switch (gray part)
B: Locked state
C:
Red part
D: Released state
DMC-FT2&TS2P-VQT2M30_eng.book 10 ページ ２０１０年１月２９日 金曜日 午後５時３１分
To Next Page
Loading...
