Panasonic Lumix DMC-TS2 User Manual

Before Use
- 8 -
Before Use
Maintenance and Waterproof Performance
∫ To prevent water leaking into the camera, observe the following items before
using it.
∫ Check that there is enough remaining battery power or memory in the card.
∫ Do not open or close the card/battery door or terminal cover in places with sand
and dust, near water, or with wet hands.
∫ At purchase, the [LOCK] switch is in the locked state. When opening the card/
battery door and terminal cover, first release the lock.
•
Release the lock by sliding the [LOCK] switch in the direction of the arrow until the red area
becomes visible, and open the card/battery door and terminal cover.
Confirm that there are no foreign objects on the inner side of the
card/battery door or terminal cover (B rubber seal and C place
where rubber seal meets).
• If there is any crack or deformation in the rubber seal inside the card/battery door and terminal
cover, get the camera inspected or repaired by the dealer or an authorized Panasonic Service
Center.
A: [LOCK] switch (gray part)
B: Locked state
C:
Red area
D: Released state
A: Terminal cover
B: Rubber seal
C: Area where rubber seal
sits
D: Card/Battery door
E: Hair and lint
F: Sand and dust
G: Crack and deformation
H:Fluid

Panasonic Lumix DMC-TS2 Specifications

General

Brand	Panasonic
Model	Lumix DMC-TS2
Category	Digital Camera
Language	English