- 53 -
Taking pictures with flash
●
The effect of red-eye reduction varies depending on the subject and is affected by
factors such as distance to the subject, whether the subject is looking at the camera
during preliminary flash, and so on. In some cases, the effect of red-eye reduction may
be negligible.
●
Flash settings may be changed when changing recording mode.
●
Scene Mode flash settings are restored to default when Scene Mode is changed.
●
No pictures may be taken if these marks (e.g. ) are flashing (flash is charging).
●
If light from the flash on a subject is insufficient, neither the proper exposure nor White
Balance is achieved.
●
The flash effect may not be sufficient in the following cases:
• Slow shutter speed
• [Flash Burst] is set
●
Flash charging may take time if battery is low, or if using flash repeatedly.
■
Available types in each mode (○: Available, –: Not available, : Default setting)
[Scene Mode]
○
∗
1
○ ○ ○ ○ ○
–
○ ○ ○ ○ ○
–
○ ○ ○ ○
– – –
○
– – –
–
○ ○ ○ ○ ○
–
○ ○ ○ ○ ○
–
○
– – – –
○
– – – – –
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
∗
1
Set to , , or depending on the subject and brightness.
• The flash cannot be used when recording motion pictures or in the , , , ,
, and Scene Modes.
■
Shutter speeds for each flash mode
1/60
∗
2
- 1/4000th
1
∗
2
∗
3
- 1/4000th
∗
2
Varies according to [Min. Shtr Speed] setting.
∗
3
When [Min. Shtr Speed] is set to [AUTO], and a jitter is detected when [Stabilizer] is turned to
[ON], the maximum speed is 1/4 second. Also varies according to [Intelligent Auto] Mode and
Scene Modes, etc.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
