- 52 -
Taking pictures with flash
Recording mode:
Press to display [Flash]
Use cursor button to select the desired type and press [MENU/
SET]
Type, operations Uses
∗
1
[Auto]
• Automatically judges whether or not to flash
Normal use
[Auto/Red-Eye]
∗
2
• Automatically judges whether or not to flash
(reduce red-eye)
Taking pictures of subjects in dark
places
[Forced Flash On]
• Always flash
Taking pictures with backlight or
under bright lighting (e.g. fluorescent)
[Slow Sync./Red-Eye]
∗
2
• Automatically judges whether or not to flash
(reduce red-eye; slow shutter speed to take
brighter pictures)
Taking pictures of subjects against a
nightscape (tripod recommended)
[Forced Flash Off]
• Never flash
Places where flash use is prohibited
∗
1
Only in the mode
∗
2
Two flashes will be emitted. Do not move until after the second flash. Interval between flashes varies
according to brightness of subject.
If [Red-Eye Removal] on the [Rec] menu is [ON], the
appears with the flash icon, red-eye
is automatically detected and still picture data is corrected. (Only when [AF Mode] is
(Face
Detection))
■
The available flash range when [Sensitivity] setting is [AUTO]
Max. W Approx. 0.6 m-6.4 m (2.0 - 21 feet)
Max. T Approx. 1.0 m-3.5 m (3.3 - 11 feet)
●
Do not put your hands over the light-emitting area of the flash (→8) or look at it
from close range (a few centimetres away).
Do not use the flash at close distances to other subjects (heat/light may damage
subject).
●
Edges of picture may become slightly dark if using flash at short distances without
using zoom (close to max. W). This may be remedied by using a little zoom.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
