70 VQT3G90 VQT3G90 71
Burst function
Recording Mode:
A burst of still pictures can be recorded while the shutter button is pressed fully.
Select [Burst] from the [Rec] menu
Use cursor button to select the burst setting, and press
[MENU/SET]
Setting Speed Description
No. of
pictures
Approx. 2 - 10
pictures/sec.
• The burst speed is adjusted automatically in
accordance with the movements of people, pets
or other subjects. ([Intelligent Burst mode])
• This setting can be selected only in the
[Intelligent Auto] Mode.
100
Approx. 2
pictures/sec.
• The subject is brought into focus as far as this
is allowed by the burst speed. The pictures are
taken with the burst function while the exposure
and White Balance are being adjusted.
(However, when the burst function is operating
during motion picture recording, the focus is
fixed to the first picture.)
• The burst speed may be reduced under certain
recording conditions.
100
Approx. 5
pictures/sec.
Approx. 10
pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
15
40 pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
• Number of recording pixels that can be set
[Aspect Ratio] [Picture Size]
4:3 5M, 3M, 0.3M
3:2 4.5M, 2.5M, 0.3M
16:9 3.5M, 2M, 0.2M
1:1 3.5M, 2.5M, 0.2M
50
60 pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
• The recordable range is reduced.
• Number of recording pixels that can be set
[Aspect Ratio] [Picture Size]
4:3 2.5M, 0.3M
3:2 3M, 0.3M
16:9 3.5M, 0.2M
1:1 2M, 0.2M
60
[OFF] — The burst function is released. —
●
Pictures taken with the or setting are recorded together as a group (burst
group). (→99)
●
Depending on changes in the brightness of the subject, the second and subsequent
pictures may be recorded brighter or darker when using the burst function at the ,
or setting.
●
Burst speed may be reduced if shutter speed is reduced in darker locations.
●
The pictures taken using the burst function at the or setting may be distorted if
the subjects were moving or the camera was moved.
●
[Auto Bracket] is released.
●
The flash is set to [Forced Flash Off].
●
Settings will be stored even if power is turned off.
●
Burst is not available in the Scene Modes [Panorama Assist], [Handheld Night Shot],
[Flash Burst], [Starry Sky], [Fireworks], [Pin Hole], and [Photo Frame].
●
When [Selftimer] is set, 3 pictures are taken.
●
It may take a while to store still pictures that were taken using the burst function.
To Next Page
Loading...
Need help?
General
