Application (Record)
Setting the burst function
- 120 - VQT4J15
●
When [ ] is set, the recording range will be narrower.
●
Pictures taken with the [ ] or [ ] setting are recorded together as a group (group
display). (→156)
●
Depending on changes in the brightness of the subject, the second and subsequent
pictures may be recorded brighter or darker when using the burst function at the [ ],
[ ], [ ] or [ ] setting.
●
Even if [ ] or [ ] is set, the focus is fixed on the first picture when the burst
function is used during motion picture recording.
●
Burst speed may be reduced if shutter speed is reduced in darker locations.
●
The pictures taken using the burst function at the [ ] or [ ] setting may be distorted
if the subjects were moving or the camera was moved.
●
The flash is set to [ ] (Forced flash off). (Excluding [ ])
●
Settings will be stored even if power is turned off.
●
The burst function cannot be used in the following cases:
• [Creative Control] Mode ([Toy Effect] [Miniature Effect] [Soft Focus] [Star Filter]
[Smooth Defocus] [Radial Defocus])
• Scene Modes ([Panorama Shot] [Handheld Night Shot] [HDR] [3D Photo Mode])
• During Interval Recording
●
When [Intelligent Auto] mode is set or Scene Mode is set to [Night Portrait] or [Night
Scenery], [ ], [ ] and [ ] cannot be selected.
●
With repeated recordings, it may take a while between recordings, depending on the
usage conditions.
●
It may take a while to store still pictures that were taken using the burst function. If
you continue to record while storing, the number of burst pictures that can be taken
will be reduced. A high-speed card is recommended when recording using the burst
function.
●
You cannot use zoom during burst recording.
To Next Page
Loading...
Need help?
General
