Panasonic MC-CG937

- 50 -
➢ Install new belt in belt path on the
agitator assembly, then over the
motor shaft. See. CONSUMABLE
PARTS.
➢ Place agitator assembly back into
Power Nozzle.
➢ Line up front of cover and base.
➢ Rest cover on front edge of base
as shown.
➢ Tilt cover to back.
➢ Press cover firmly until latches
snap into place.
➢
Replace cover screws.
Motor Shaft
Entraînement
du moteur
Impulsor del motor
Belt Path
Chemin de courrioe
Ruta de la correa
End Cap
Capuchon d’extrémité
Tapa del extremo
Agitator
Agitateur
Agitador
Base
Base
Base
Cover
Couvercle
Cubierta
Side Latch
Pestillos laterales
Languette latérale
Rear Latches
Pestillos traseros
Languette arrière
Replacing Belt