Panasonic MX-MG5351 - Blender and Mill Parts Identification; Blender and Mill Component Details; Overload and Overheating Protection; Overload Protection Mechanism

EN5
English
Parts Names and Instructions
Control
Motor
Overload and Overheating Protection
In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
1
Press "0" button, unplug the appliance.
2
jug, it also can add liquid.)
3
Reset the attachment, then start again.
If the appliance still does not operate after performing the above, overheating protection has been activated.
Press "0" button, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a normal temperature) to
release overheating protection before using again.
MX-MG5351 Glass
The Safety Lock has been designed to prevent the appliance from switching on when blender jug or mill container is not properly in place.
Note:
• Do not push the Safety Lock Pin and any Safety Levers with any instrument such as stick.
• Do not pour liquids or ingredients at the Safety Lock Pin and Control Panel area.
• Keep the Safety Lock Pin and Safety Lever area clean to avoid foreign particles accumulating in the area.
Control Panel
Ice Crush
Crush
Mill Container
Mill Gasket
Mill Blade
Mill Container Base
Illustrations of product in this
Blender Gasket
Blender Blade
Blender Wet & Dry Mill