Blender Wet & Dry Mill
Power supply
Power consumption
Rated time
Continuous operation (Repeat the cycle of 3 Continuous operation (Repeat the cycle of 1
Working capacity
Dry
MX-MG5351
Before calling for service, please check through this section.
Problem Cause and Action
Troubleshooting
The appliance does
not turn on.
The blender jug
/
mill container is not set properly.
/
The blender jug base
/
mill container base is not assembled tightly.
The protection device of overload or overheating is activated.
The power plug is disconnected.
Rotation stops
abruptly.
The protection device of overload or overheating is activated.
There is abnormal
noise or vibration
increases.
The Rubber Feet and/or the work top are not clean.
flat surface.
Too much ingredients.
The blender jug base / mill container base is not assembled tightly.
consistency of
the processed
ingredients do not
turn out well.
Some ingredients might be too difficult to process raw, e.g. pumpkin.
Ingredient size is not according to the preparation method.
The ingredient is
leaking.
The blender jug base
/
mill container base is not assembled tightly.
The blender gasket
/
mill gasket is not attached or attached loosely.
Attach it properly.
Foreign matters are stucked around blender gasket
/
mill gasket.
The blender gasket
/
mill gasket is damaged.
The blade is idling.
The liquid amount is not enough.
Too much ice cubes.
To Next Page
Loading...
