Select a spin speed.4.
If you select a spin speed which is
higher than the speed available (see
page 22-23), then the max. speed is
applied.
Select optional functions.5.
Krótkie pranie (Time Saver) function -
(See page 26.)
Temperature (See page 16.) -
Preset timer (See page 26.) -
Add detergent to the detergent 6.
drawer.
(See pages 13-15.)
Press the Start button.7.
The appliance starts supplying water
after draining.
Note
Whenever you start washing, the -
process display flashes to show
which function is in progress.
Before any programme is started, the -
appliance first drains out any water.
The buzzer will sound and “END”
will flash on the display when the
programme has finished, and the door
will unlock immediately.
Caution
After a high temperature wash, be
careful to not burn yourself when
handling the laundry or touching
the inside of the drum.
Note
If the load is big, the laundry may -
stick to the inside of the drum. This
is normal.
Leave the appliance door open -
to allow the drum to dry out after
removing the laundry.
Remove the laundry and rearrange -
where necessary. Do not leave it in
the drum too long after the programme
ends, because colours may run.
Required time
Times depend on the programmes and
temperature settings that have been
selected.
Actual times may differ slightly from -
those shown.
The displayed times include the time -
needed for the water to fill up and to
drain out, thus they vary depending on
water pressure, drainage and amount of
laundry.
If the laundry in the drum needs to be -
balanced, times will be extended.
Setting the buzzer
To turn on or turn off the buzzer which
sounds when the programme has finished,
follow these instructions.
Simultaneously press and hold the
Temperature and Czas (Time) buttons
for at least 3 seconds.
The buzzer setting will be turned off after
a beep is heard.
The buzzer setting will be turned on after
two beeps are heard.
Changing settings
After washing has started, the programme,
temperature, preset time and Krótkie
pranie (Time Saver) function cannot be
changed.
To change the programme, temperature,
preset time, or Krótkie pranie (Time Saver)
function settings, turn the appliance off and
then on again.
To Next Page
Loading...
